ATTENTION! Please place the goods on after unpacking and before assembly
Check damage quality defects. Please contact us immediately,
if something is wrong.

ASSEMBLY INSTRUCTIONS FOR ALUMINIUM / STAINLESS STEEL MUDGUARDS


1. For a permanent hold, clean the mounting surface very thoroughly and
remove all paint protection substances, wax or similar dirt.
Detergents with greases or silicone prevent a permanent hold of the
Door sills
2. Do not remove the adhesive protection strip – check the accuracy of fit in advance,
if the goods do not fit exactly, please sit down with us immediately in
Connection.
3. Select the assembly point
4. Adhesive protection strips can now be removed
5. Insert the door sills exactly to the markings at the back and easily after
press in at the bottom.

Attention! The adhesive tape adheres immediately and very strongly, a correction is usually
not possible and can lead to damage to the bar.

Mounting temperature is 15 °C - 30 °C
If the temperature is not given due to the weather, the mounting surface can be connected with a
Hot air dryer should be warmed up.

INSTALLATION INSTRUCTIONS PAINT PROTECTION FILM

First of all, the substrate must be cleaned well. Remedies have proven themselves here
such as distilled spirit or glass cleaner.
Before use, the detergent should be checked for paint compatibility
become

WET BONDING
To be able to mount the film better and to make small direction corrections during
of the assembly possible, the bumper or the entrances with a flower sprayer which is filled with normal water should be sufficient
sprinkle. Now the actual assembly takes place. Experience has shown that there are two people here
helpful. Completely detach the paint protection film from the carrier film and moisten it with water.
Now the foil is held at both ends and from the middle on the
Bumper or entrances. If the direction requires correction, then completely peel off the foil and apply it again. Now the foil is started from the middle and the water and bubbles are painted out. Here the rubber side of an ice scraper is recommended. To fasten the edges, it is recommended to use a hot air gun or a hair dryer (pay attention to temperature here!)

DRY BONDING
Before detaching the paint protection film/door sills from the carrier film, place the
individual parts in the appropriate places to ensure that the cut is right and the size fits. Now the actual assembly takes place. Experience has shown that 2 people are helpful here. Completely detach the paint protection film from the carrier film. Now the foil is held at both ends. Now carefully position the film without coming into contact with the surface. When you have found the right adhesive position, carefully glue the film from right to left. If the direction requires correction, then peel off the slide and correct direction. To fasten the edges, it is recommended to use a hot air gun or a hair dryer (pay attention to temperature here!) The film is wash-proof after about 48 hours.

Mounting temperature is 15 °C - 30 °C
If the temperature is not given due to the weather, the mounting surface can be heated with a hot air dryer.

Video tutorial:

https://youtu.be/WB6W1fq2Oso